Predator Bull bar, Ford Ranger PX2; 2015-2018

Offroad Animal Predator Bull Bar – Ford Ranger PX2 (2015–2018)

The Predator gives the PX2 Ranger a lower-profile front bar with the mounting space needed for a winch, additional lighting and optional recovery points, without going to a traditional full-height bull bar.

It replaces the factory bumper, works with Tech Pack vehicles and parking sensors, and sits approximately 150–160mm forward of the grille.

Vehicle Fitment

Suits Ford Ranger PX2 models from 2015 to 2018.

The Predator is:

• ADR compliant
• Airbag compatible
• Compatible with Tech Pack vehicles
• Compatible with factory parking sensors
• Full bumper replacement
• No cutting of the factory bumper required

Winch Setup

The integrated winch cradle suits most low-mount winches up to 12,000lb, including the Warn Zeon.

The winch mounts feet-down and can be installed after the bull bar has already been fitted, making later installation and maintenance easier.

A winch control-box bracket and number plate flip are supplied with the bar.

Lighting Options

The centre of the Predator can take a single-row LED light bar up to 22 inches.

In the wings, you can retain the factory fog lights or fit:

• Up to 2 x cube lights per side
• Up to an 8" LED light bar per side

If you do not want to run a centre light bar, a matching cover plate is available.

Optional Upper Hoops

The Predator can also be fitted with Offroad Animal's bolt-on upper hoop options.

The Stealth Hoop can take a compatible 22" single-row LED light bar, while other hoop configurations are available if you want a different lighting or upper-protection setup.

Hoops and lighting are sold separately.

Optional Recovery Points

Optional 24mm steel tow hooks are available for the Ranger.

Each tow point is rated to 4.5 tonnes.

Construction & Finish

The Predator uses a one-piece welded steel bar with welded wing supports.

It is zinc plated before being finished in matte black powder coat, with colour coding also available.

Hi-lift jacking points are incorporated into the bar.

What's Included

• 1 x front bar weldment
• 1 x LH chassis impact bracket
• 1 x RH chassis impact bracket
• 1 x mesh fairlead mount
• 1 x LH mesh infill
• 1 x RH mesh infill
• 1 x LH light-cover mesh
• 1 x RH light-cover mesh
• 1 x LH fog-lamp bracket
• 1 x RH fog-lamp bracket
• 1 x LH headlight infill
• 1 x RH headlight infill
• 1 x centre bash plate
• 1 x LH under-wing panel
• 1 x RH under-wing panel
• 1 x LH chassis-bracket gusset
• 1 x RH chassis-bracket gusset
• 1 x winch control-box bracket
• 1 x number plate flip
• Fitting hardware

For a PX2 Ranger being set up with a winch and extra lighting, the Predator gives you the strength and accessory mounting points of a proper steel bar while keeping the front end more open than a full-height design.