Toro bull bar to suit, Landcruiser 80 series 1990-1997

Offroad Animal Toro Bull Bar – Toyota LandCruiser 80 Series (1990–1997)

The Toro gives the 80 Series a full-height steel bull bar with provision for a winch, recovery points and additional lighting, while keeping the front setup practical for off-road use.

It is designed specifically for the LandCruiser 80 Series and gives you front-end protection without going to an oversized five-post style bar. The winch can also be fitted and accessed through the front of the bar, so the bull bar does not need to come back off for installation or maintenance.

Vehicle Fitment

Suits Toyota LandCruiser 80 Series models from 1990 to 1997.

Important: this bar is designed for:

• Right-hand-drive vehicles only
• Vehicles without airbags

Check your vehicle before ordering.

Steel Construction

The Toro uses:

• 3mm steel through the main body and wings
• 5mm steel mounts and winch cradle
• 16mm high-tensile steel recovery points

The bar is fully zinc plated before being finished in matte black powder coat, giving the steel additional corrosion protection underneath the final finish.

Winch Setup

A winch cradle is built into the bar and suits winches up to 12,000lb.

The winch can be installed through the front of the bar, making initial installation and later maintenance easier without needing to remove the complete bull bar.

Recovery Points

Two 16mm high-tensile steel recovery points are included as standard.

Each recovery point is rated to 4 tonnes.

Lighting Options

The Toro includes multiple positions for auxiliary lighting, including an integrated mounting position for a 32" LED light bar.

For fog-light setups, the bar can also accommodate:

• 2 x STEDI Type A LED fog lights
• STEDI Boost Integrated Driving Lights for Type A fog housings

Lighting and fog lights are not included.

Approach Angle

The Toro is designed to maintain a good approach angle, making it better suited to an 80 Series that is actually being used off-road rather than fitting a large bar that hangs unnecessarily far forward or low.

Finish

Supplied in matte black powder coat over full zinc plating.

Key Features

• Full steel bull bar
• 3mm steel body and wings
• 5mm steel mounts and winch cradle
• 16mm high-tensile recovery points
• 4-tonne rated recovery point per side
• Winch cradle included
• Suits winches up to 12,000lb
• Winch accessible through the front of the bar
• Integrated 32" LED light-bar position
• Provision for Type A fog-light options
• Matte black powder-coated finish
• Full zinc plating
• Designed for good off-road approach angle

For an 80 Series being set up for touring, recovery work or tougher tracks, the Toro gives you a proper full-height bull bar with the winch, recovery and lighting mounting points already built in.